Step 1:
Turn off the power at the GFCI for 1 minute, and then turn it back on. If the message clears, it was likely a false error reading. Your spa should now return to its normal operation.
Step 2:
Slide the pivot out of rocker.
Step 3:
Place the pivot piece as shown with the “hooks” facing down. Use a pencil to draw a line on either side of the pivot.
Step 4:
Fill the space between the lines with Super Glue. Don’t let it run into the top and bottom holes.
Step 5:
Hold the pivot until the super glue begins to set, (30- 60 seconds). Consider wearing rubber gloves for this; I didn’t and my fingers stuck to everything for 5 minutes.
Step 6:
Slide the rocker back into the pivot. It goes in easily and the magnets keep it in place.
Step 7:
The completed rocker system looks like this and operates much better than the original rubber buttons.
