Day: September 25, 2024

Balboa TP600 Control Panel with BP7 Control Box Settings

Welcome back! Today we are going over setting up your spa needs with the TP600 control panel.

NOTE:  We will need to turn the dipswitch number 1 on, on your circuit board, it is recommended to do so while the power is off.

NOTE:  You must exit priming mode by pressing the top side’s temp-up button.

Once you have exited priming mode press the temp up button once again to enter the settings menu

• This “T” screen will be flashing

• Press the Temp up button once again and then light to enter the “Test” mode

• Press the Temp up button and you will enter “Setp”

• Press Temp up button once again and you will enter this screen (for choosing the set up #)

Notice the “–” this indicates the current setting. Select the setting that you require and then select the light button, this will save the setting you will see “Mem Rset” on your screen.

Once you have done this, power off the spa turn your dipswitch number one off, and then you can power the spa back up. 

• Here is a flow chart for the buttons

NOTE: It is important to base directly of the settings chart in your spa pack lid. This will make sure you are selecting the right setting for your needs. It may need wiring (on previous blogs) to get the setup for you 😊

David Gomez